[USED] Warm Audio WA-47Jr Large-Diaphragm Condenser Microphone
Used - Good Condition
This item has been checked by LiveWire Music Store. It is fully operational with very few signs of use such as minor scratches (no dents).
Son of ’47
Compared to tube-based microphones, solid-state microphones like the Warm Audio WA-47jr are prized for their detailed sound and resistance to distortion. These are the reasons transformer-less FET mics with a U47-style capsule are so popular on kick drums and other percussion instruments, capturing their power and intensity with amazing fidelity. So naturally, the WA-47jr shines on percussion. That said, it’s also a go-to choice for acoustic instruments where capturing fast transients is critical, and it should be on your short list of mics to audition on vocalists, electric guitar cabs, and a whole lot more. Perhaps the more pertinent question is: what isn’t it great on? Get it here today at LiveWire Music.
Features
- Fully discrete, transformerless signal path
- Custom ’47-style k47 34mm gold-sputtered, dual-diaphragm, single–back plate, 6 micron Mylar capsule
- Toshiba FETs, Wima film capacitors, Panasonic electrolytic capacitors
- Cardioid, figure-8, and omnidirectional polar patterns
- 10dB pad; 70Hz highpass filter
- Self-noise: 9dBA
- Dynamic range: 138dBA
- Maximum SPL: 147/157dB (at 1kHz, 1 Kohm, 0.5% THD, 0/-10dB)
- Frequency range: 20Hz–20kHz
- Sensitivity: 10mV/Pa or -40dB
- Output impedance: 100 ohms
- Rated load impedance: ≥1 Kohm
- Maximum output: 16dBu at 1kHz, 1 Kohm, 0.5% THD
- S/N ratio: 85dBA (IEC651)
- Equivalent noise: 9dBA (IEC651)
- Dynamic range: 138dBA (IEC651)
- 48-volt phantom powered
- 3-pin gold-plated XLR connector
- Includes shockmount and hardmount
To Custom-Order another variant, click here.